LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Shift Control Linkage Adjustment

Shift Control Linkage Adjustment

  1. Position the shift lever in PARK.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Identifying Shift Control Linkage Rod
    GM1954218Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Loosen the shift control linkage adjustment bolt to allow the adjuster (1) to slide freely.
  4. Hold the selector lever on the transmission against the rear stop to eliminate any play. Tighten the shift control linkage adjustment nut 9 N.m (80 lb. in).
  5. Lower the vehicle.
    6. Fig 2: Identifying Shift Lever Positions
    GM1955734Courtesy of GENERAL MOTORS CORP.
  6. Check the operation of the starting system with the shift lever in each position. The engine should only crank when the lever is in the PARK or NEUTRAL position.
scientia non olet · About LEMON Manuals