Installation Procedure

Fig 1: Exploded View Of PCS

Courtesy of GENERAL MOTORS CORP.

Install new O-ring seals (3-4) to the pressure control solenoid (1), if the O-rings were previously removed.
Install the pressure control solenoid (1) into the control valve body.

Fig 2: Locating Solenoid Retainer

Courtesy of GENERAL MOTORS CORP.

Install the pressure control solenoid retainer into the control valve body.

Fig 3: View Of PCS & Electrical Wiring Harness Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (2) to the pressure control solenoid (1).
Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .

IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

Reset the TAP values. Refer to Transmission Adaptive Functions .