LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Case Components Assemble

Case Components Assemble

    Fig 1: Identifying Pressure Test Hole Plug & Transmission Fluid Level Hole Plug
    GM856325Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: If the pressure test plug (40), O-ring (66), level hole plug (36) and O-ring (37) are not damaged, they should be reused.
  1. Inspect the pressure test hole plug (40) and O-ring seal (66) for damage.
  2. Install the pressure test plug (40) and O-ring seal (66) and tighten to 11N.m (8 lb ft).
  3. Inspect the fluid level hole plug (36) and O-ring seal (37) for damage.
  4. Install the transmission fluid level hole plug O-ring seal (37) and the transmission fluid level hole plug (36) and tighten to 20N.m (15 lb ft).
scientia non olet · About LEMON Manuals