LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Automatic Transmission Fluid Pressure Test Hole Plug Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Oil Pressure Test Plug
    GM1955702Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install a NEW oil pressure test plug and tighten to 11 N.m (97 lb. in).
  2. Check the transmission fluid level. Fill if necessary. Refer to Transmission Fluid Check .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals