Radio Replacement

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Radio

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the bezel instrument panel (I/P) center air outlet trim plate. Refer to Instrument Panel Center Air Outlet Bezel Replacement . Remove the control assembly heater air conditioning (A/C). Refer to HVAC Control Module Replacement .
1	Radio Screw (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2.5 N.m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connectors. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References .

Callout

Component Name

Preliminary Procedures

Remove the bezel instrument panel (I/P) center air outlet trim plate. Refer to Instrument Panel Center Air Outlet Bezel Replacement .
Remove the control assembly heater air conditioning (A/C). Refer to HVAC Control Module Replacement .

Radio Screw (Qty: 4)

NOTE: Refer to Fastener Notice .

Tighten: 2.5 N.m (22 lb in)

Radio Assembly

Procedure

Disconnect the electrical connectors.
Disconnect the antenna cable.
Reprogram the radio after replacement. Refer to Control Module References .