Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Install the engine support fixture. Refer to Engine Support Fixture .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the air conditioning (A/C) compressor. Refer to Compressor Replacement (LNJ) or Compressor Replacement (LY7) .
- Remove the engine-to-transaxle brace bolts (1, 2).
- Remove the engine-to-transaxle brace (3).
- Remove the starter. Refer to Starter Motor Replacement (LNJ) or Starter Motor Replacement (LY7) .
- If equipped with all wheel drive (AWD), remove the transfer case. Refer to Transfer Case Replacement
- If equipped with front wheel drive (FWD), remove the intermediate shaft. Refer to Intermediate Shaft Replacement .
- Drain the engine oil and remove the oil filter. Refer to Engine Oil and Oil Filter Replacement .
- Remove the oil pan side bolts.
- Remove the oil pan sealing surface bolts.
- Remove the oil pan.
- Clean the oil pan and the engine block gasket surface.