Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the transmission mount to the frame.
- Install the transmission mount-to-frame bolts.
Tighten: Tighten the bolt to 50 N.m (37 lb ft).
- Install the transmission mount-to-bracket through bolt, while aligning the transmission mount to the bracket.
Tighten: Tighten the bolt to 110 N.m (81 lb ft).
- If equipped with AWD, lower the stabilizer shaft and connect the stabilizer links.
Tighten: Tighten the stabilizer link nuts to 65 N.m (48 lb ft).
- Install both front tires and wheels. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
.