Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the transmission mount on the frame rail.
- Install the transmission mount to frame rail bolts.
Tighten: Tighten the bolts to 37 N.m (27 lb ft).
- Install the transmission mount to transmission bolts.
Tighten: Tighten the bolts to 55 N.m (41 lb ft).
- Install the battery tray. Refer to Battery Tray Replacement .
- Remove the engine support. Refer to Engine Support Fixture .
NOTE:
Refer to Fastener Notice
.