Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Transaxle Cooler Lines & Nut

Courtesy of GENERAL MOTORS CORP.

Install the transaxle oil cooler lines into the vehicle.
Install the transaxle oil cooler line assembly (1) to the transaxle.

NOTE: Refer to Fastener Notice .

Install the transaxle oil cooler line assembly nut (2).
Tighten: Tighten the transaxle oil cooler lines to 9 N.m (80 lb in).
Connect the lower transaxle oil cooler line to the radiator.

Fig 2: View Of Transaxle Oil Cooler Lines At Fan Shroud

Courtesy of GENERAL MOTORS CORP.

Engage the transaxle oil cooler lines with the fan shroud by snapping in place.
Lower the vehicle.

Fig 3: View Of Transmission Cooler Lines At Radiator

Courtesy of GENERAL MOTORS CORP.

Connect the upper transaxle oil cooler line to the radiator.

IMPORTANT: DEXRON® VI automatic transmission fluid is not compatible with this transaxle. If DEXRON® VI ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid P/N 88900925.

Add fluid to the transaxle. Refer to the Transmission Fluid Check .
Start the engine a check for leaks.