LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Input Speed Sensor With Bolt
    GM1827301Courtesy of GENERAL MOTORS CORP.
  1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new input speed sensor O-ring.
  2. Install the new input speed sensor O-ring onto the input speed sensor.
  3. Install the input speed sensor to the transaxle.
    4. NOTE: Refer to Fastener Notice .
  4. Install the input speed sensor bolt.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in).

    5. Fig 2: Identifying Electrical Connector & Input Speed Sensor
    GM1827300Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (4) to the input speed sensor.
  6. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals