Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Using the J 44809 , install the left axle seal into the transaxle. See Special Tools .
- Install the left front axle shaft. Refer to Front Wheel Drive Shaft Replacement .
- Lower the vehicle.
- Inspect the transaxle fluid level. Refer to Transmission Fluid Check .
IMPORTANT:
Dextron®III automatic transmission fluid is not compatible with this transaxle. If Dextron®III ATF is used, transaxle failure will result. This transaxle uses GM T-IV fluid GM P/N 88900925.