LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Fluid Cooler Pipe Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
  2. Place a drain pan or suitable container under the vehicle.
    3. Fig 1: View Of Transaxle Oil Cooler Line Assembly
    GM945444Courtesy of GENERAL MOTORS CORP.
  3. Remove the transaxle oil cooler line assembly nut from the transaxle.
  4. Disconnect the transaxle oil cooler lines from the vehicle.
    5. Fig 2: View Of J 45201
    GM792754Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the J 45201 is fully seated into the transaxle seal bore.
  5. Insert the collet piece (2) of the J 45201  into the cooler line seal. See Special Tools .
  6. Insert the forcing screw piece (1) of the J 45201  into the collet (2). See Special Tools .
  7. Tighten the forcing screw (1) until snug.
    8. Fig 3: Identifying Collar & Collet
    GM853327Courtesy of GENERAL MOTORS CORP.
  8. Thread the collar piece (1) of the J 45201  onto the collet (3) until snug. See Special Tools .
    9. Fig 4: Illustrating Turning Collar Clockwise To Remove Cooler Line Seal
    GM853328Courtesy of GENERAL MOTORS CORP.
  9. Turn the collar clockwise in order to remove the cooler line seal (87).
  10. Discard the seal (87).
  11. Clean the case bores for the cooler line seals.
scientia non olet · About LEMON Manuals