Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the transmission wiring harness. Refer to Automatic Transmission Wiring Harness Replacement .
- Remove the 2 control valve body bolts/screws (31), control valve body fluid passage cover (37) and gasket (38).
- Remove the 6 control valve body mounting bolts/screws (1-6).
- While holding the control valve body assembly, disconnect the manual shift detent lever assembly (710) from the manual valve link (336).
- Move the detent lever assembly clockwise for ease of removing the manual valve.
- Remove the control valve body assembly (39).
- Remove the 2 transaxle case fluid passage seals (86).
IMPORTANT:
Place the transaxle in neutral (N).