Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Case Fluid Passage Seals

Courtesy of GENERAL MOTORS CORP.

Install 2 new transaxle case fluid passage seals (86) into the transaxle case fluid ports.

Fig 2: View Of Valve Body Assembly

Courtesy of GENERAL MOTORS CORP.

While holding the control valve body assembly (39), connect the manual valve link (336) to the manual shift detent lever assembly (710).

Fig 3: View Of Valve Body Assembly-To-Transaxle Case Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 6 control valve body assembly to transaxle case bolts and hand tighten.

Fig 4: Identifying Control Valve Body Assembly-To-Transmission Case Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Tighten the control valve body assembly-to-transaxle case bolts in sequence.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 5: View Of Control Valve Body Passage Cover Bolts, Cover & Gasket

Courtesy of GENERAL MOTORS CORP.

Install a new control valve body fluid passage cover gasket (38).
Install the control valve body fluid passage cover (37).
Install the 2 control valve body bolts (31).
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Install the transmission wiring harness. Refer to Automatic Transmission Wiring Harness Replacement .
After the transmission is reassembled and filled with fluid perform the transmission adaptive learn procedure. Refer to Transmission Adaptive Learn and Transmission Neutral Learn .