LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Control Valve Body Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Control Valve Body Cover
    GM749819Courtesy of GENERAL MOTORS CORP.
  1. Clean any gasket material from the control valve body cover and inspect the gasket mounting surface.
  2. Install a 3 mm (0.125 in) bead of RTV sealer GM P/N 89020326 (Canadian P/N 89021188) onto the control valve body cover.
    3. Fig 2: View Of Control Valve Body Cover & Bolts
    GM1418667Courtesy of GENERAL MOTORS CORP.
  3. Install the control valve body cover (1) onto the transaxle case.
    4. IMPORTANT: Use LOCTITE™ 242 thread sealer on ALL bolt threads.
  4. Install the control valve body cover bolts (2) hand tight.
    5. Fig 3: Identifying Control Valve Body Bolts/Screws Tightening Sequence
    GM749335Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Tighten the control valve body cover bolts in the sequence shown.

    Tighten:  Tighten the bolts to 13 N.m (115 lb in).

  6. Install the transaxle oil cooler lines and seals to the transaxle. Refer to Fluid Cooler Pipe Seal Replacement .
  7. Install the front engine mount. Refer to Engine Front Mount Replacement .
  8. Install the left splash shield. Refer to Engine Splash Shield Replacement .
  9. Install the left front wheel and the tire assembly. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
  11. Check the transaxle fluid level. Refer to Transmission Fluid Check .
scientia non olet · About LEMON Manuals