LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the control valve body cover. Refer to Control Valve Body Cover Replacement .
  2. Fig 1: Locating Solenoid Harness Connectors
    GM749337Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the wiring harness connectors (1-8).
  4. Fig 2: View Of Fluid Temperature Sensor
    GM749339Courtesy of GENERAL MOTORS CORP.
  5. Remove the fluid temperature sensor bolt (31).
  6. Remove the fluid temperature sensor clamp (49).
  7. Remove the fluid temperature sensor (36) and the O-ring (32) from the control valve body.
  8. Fig 3: Locating A/T Control Wiring Harness Connector & Retainer
    GM1826678Courtesy of GENERAL MOTORS CORP.
  9. Remove the A/T control wiring harness connector retainer (69).
  10. Fig 4: View Of Transmission Wiring Harness Assembly
    GM1826683Courtesy of GENERAL MOTORS CORP.
  11. Remove the transmission wiring harness assembly (33) from the transmission case assembly through the wiring harness bore.
  12. Remove the TCM seal (72) and the automatic transmission wiring connector seal (46) from the connector.