Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to a NEW transaxle wiring connector O-ring seal (46).
- Install the NEW automatic transmission wiring connector seal (46) in the bore for the connector. The taper side of the seal goes up.
- Install a NEW TCM seal (72) on the connector.
- Install the transmission wiring harness assembly (33) into the transmission case assembly through the wiring harness bore.
- Align the tab of the connector in the transmission case.
- Install the wiring harness connector retainer (69).
- Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to a new transaxle fluid temperature sensor O-ring seal (32).
- Install a new transaxle fluid temperature sensor O-ring seal (32) into the groove of the transaxle fluid temperature sensor (36).
- Install the transaxle fluid temperature sensor (36) into the front control valve body fluid temperature sensor bore.
- Install the transaxle fluid temperature sensor clip (49).
- Install the fluid temperature sensor bolt (31).
Tighten: Tighten the bolt to 10 N.m (89 lb in).
- Connect the 8 solenoid wire connectors as follows:
- 1 blue
- 2 black
- 3 green
- 4 black
- 5 blue
- 6 gray
- 7 brown
- 8 black
- Install the control valve body cover. Refer to Control Valve Body Cover Replacement .
- Perform the transmission adaptive learn procedure. Refer to Transmission Adaptive Learn and Transmission Neutral Learn .
NOTE:
Refer to Fastener Notice
.