Transmission Fluid Baffle Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Automatic Transmission Case Fluid Passage Cover

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the 2 - M6 x 1.0 x 14 mm transmission case fluid passage cover bolts (41).
Tighten: Tighten the transmission case fluid passage cover bolts to 5 N.m (44 lb in).

Fig 2: View Of Automatic Transmission Fluid Baffle

Courtesy of GENERAL MOTORS CORP.

Install the transmission fluid baffle (44).
Install the 3 - M6 x 1.0 x 14 mm transmission fluid baffle bolts (45).
Tighten: Tighten the transmission fluid baffle bolts to 5 N.m (44 lb in).