Torque Converter Housing Cleaning and Inspection

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Transmission Fluid Baffle

Courtesy of GENERAL MOTORS CORP.

Remove the transmission fluid baffle bolts/screws (807) and the transmission fluid baffle (803).
Remove the lube fluid pipe retainer bolt/screw (806).
Remove the lube fluid pipe retainer (805).

Fig 2: Identifying Lube Fluid Pipe

Courtesy of GENERAL MOTORS CORP.

Fig 3: Identifying Torque Converter Housing

Courtesy of GENERAL MOTORS CORP.

Inspect the torque converter housing for damage. If the bearings are faulty, the converter housing requires replacement.

Fig 4: Identifying Lube Fluid Pipe

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not bend or damage the lube fluid pipe (804).

Fig 5: View Of Chip Collector Magnets

Courtesy of GENERAL MOTORS CORP.

Place the 4 chip collector magnets (808) onto the transmission fluid baffle (803).

Fig 6: View Of Transmission Fluid Baffle

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the transmission fluid baffle (803) and the 3 - M6 x 1.0 x 14 mm transmission fluid baffle bolts (807).
Tighten: Tighten the 3 transmission fluid baffle bolts to 5 N.m (44 lb in).
Install the lube fluid pipe retainer (805) and the M6 x 1.0 x 14 mm lube fluid pipe retainer bolt (806) into the torque converter housing assembly.
Tighten: Tighten the bolt to 5 N.m (44 lb in).