Tools Required

DT-47599  Anchor Bolt Socket. See Special Tools .

Fig 1: View Of 3rd Gear Band Assembly
Courtesy of GENERAL MOTORS CORP.
1. Install the third gear band assembly (16) into the transmission case assembly making sure that the band tangs are located at the servo pin and the 3rd gear band anchor bolt hole (64).
Fig 2: Locating 3rd Gear Anchor Bolt
Courtesy of GENERAL MOTORS CORP.
2. Inspect the anchor bolt and the bolt hole.
3. Apply automatic transmission fluid to a new O-ring (65).
NOTE: Refer to Fastener Notice .
4. Install the new O-ring and third gear band anchor bolt (64) using DT-47599  . See Special Tools .

   Tighten:  Tighten the anchor bolt to 167 N.m (123 lb ft).