Third Gear Band Apply Tube Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of 3rd Gear Band Apply Tube & Seals

Courtesy of GENERAL MOTORS CORP.

Install the 2 third gear band apply tube O-ring seals (53).
Install the third gear band apply tube (52).
If needed, lightly seat the third gear band apply tube into the transmission case assembly with a soft mallet.

Fig 2: View Of 3rd Gear Band Apply Tube Retainer

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the 2 - M6 x 1.0 x 14 mm third gear band apply tube retainer bolts (50).
Tighten: Tighten the third gear band apply tube retainer bolts to 5 N.m (44 lb in).