Tools Required

J 36850  Transjel Lubricant. See Special Tools .

Fig 1: View Of Second Clutch Sprag Assembly
Courtesy of GENERAL MOTORS CORP.
1. Install the second clutch sprag end bearing (502).
2. Install the second clutch sprag assembly (503) rotating counter clockwise while installing. If the sprag assembly will not rotate counter clockwise turn over and install again.
3. Install the second clutch sprag end bearing (502).
Fig 2: View Of Second Clutch Sprag Outer Race Assembly, Coast Clutch Hub & Coast Clutch Thrust Washer
Courtesy of GENERAL MOTORS CORP.
4. Apply J 36850  to the second coast clutch hub thrust washer (501). See Special Tools .
5. Align the tab of the washer with the hollow of the second coast clutch hub (500).
6. Install the second coast clutch hub thrust washer (501) onto the second coast clutch hub (500).
7. While turning the second coast clutch hub (500) clockwise, slide it into the second clutch sprag outer race assembly (505).
Fig 3: Identifying Second Coast Clutch Hub For Proper Movement
Courtesy of GENERAL MOTORS CORP.
8. Hold the second clutch sprag outer race assembly, and inspect that the second coast clutch hub turns freely clockwise (2) and locks counterclockwise (1). If the hub does not turn clockwise turn the sprag race assembly over.
Fig 4: View Of Second Clutch Sprag Outer Race Assembly & Thrust Washer
Courtesy of GENERAL MOTORS CORP.
9. Install the second clutch sprag outer race thrust washer (506) aligning the tabs with the hollow of the second clutch sprag outer race assembly (505).