LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Output Gear Assembly Removal

Output Gear Assembly Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Output Gear Assembly & Retaining Ring
    GM749506Courtesy of GENERAL MOTORS CORP.
  1. Rotate the transmission assembly so the I.D. tag is facing up.
  2. Remove the output gear retaining ring (48) from the output gear assembly (12).
    3. Fig 2: View Of Output Gear Assembly
    GM749507Courtesy of GENERAL MOTORS CORP.
  3. Remove the output gear assembly (12) from the transmission case assembly.
    4. IMPORTANT: Do not disassemble the output drive gear.
  4. Clean the output gear in solvent and air dry. Ensure the solvent is removed from the bearing.
  5. Inspect the bearings feel for roughness or noise.
  6. Inspect the gear teeth for:
    • Excessive wear
    • Chips or broken teeth
    • Metal embedded in the teeth
  7. Replace the output drive gear as an assembly if any of the above conditions are found.
scientia non olet · About LEMON Manuals