Tools Required

WARNING: This page is about a different variant/trim than selected.

J 45161 Manual Shift Shaft Bearing Replacer. See Special Tools .

Fig 1: View Of Manual Shift Shaft Bearing Installation

Courtesy of GENERAL MOTORS CORP.

Using J 45161 and a hammer, install the manual shift shaft bearing (714) into the transmission case assembly until J 45161 is flush with the case bore. See Special Tools .

Fig 2: View Of Manual Shift Shaft Seal Assembly

Courtesy of GENERAL MOTORS CORP.

Install the manual shift shaft seal (713) by pressing the seal into the case bore by hand.