Input and Output Speed Sensor Installation
WARNING: This page is about a different variant/trim than selected.
- Install NEW speed sensor O-rings (63).
- Install the output speed sensor (62) and the input speed sensor (73).
- Install the M6 x 1.0 x 16 mm speed sensor bolts (61).
Tighten: Tighten the speed sensor bolts (61) to 5 N.m (44 lb in).
- Connect the input and output speed sensor harness assembly (71) to the speed sensors and the TCM.
NOTE:
Use care when installing the speed sensors or damage may occur to the speed sensors or the transaxle case.
NOTE:
Refer to Fastener Notice
.