Drain Plug Installation
WARNING: This page is about a different variant/trim than selected.
- Install a new gasket (820) on the drain plug (819).
- Install the drain plug (819) into the case assembly (17).
Tighten: Tighten the drain plug to 39 N.m (29 lb ft).
- Install the vent hose assembly.
- Install a new o-ring (824) on the transmission fluid level indicator and lubricate with transmission fluid.
- Install the transmission fluid level indicator.
- Install the transmission fluid level indicator bolt.
Tighten: Tighten the indicator bolt to 10 N.m (89 lb in).
NOTE:
Refer to Fastener Notice
.