LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle - AF33-5 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> 3rd Gear Band Servo Piston Installation

3rd Gear Band Servo Piston Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of 3rd Gear Band Servo Piston Assembly & Compression Spring
    GM749477Courtesy of GENERAL MOTORS CORP.
  1. Apply automatic transmission fluid to the third gear band servo bore in the transmission case.
  2. Install the third gear band servo compression spring (56) and the third gear band servo piston assembly (57) to the transmission case.
    3. Fig 2: View Of 3rd Gear Band Servo Cover
    GM773168Courtesy of GENERAL MOTORS CORP.
  3. Apply automatic transmission fluid to the 2 new third gear band servo cover O-ring seals (58).
  4. Install the third gear band servo cover O-ring seals (58) onto the third gear band servo cover (59).
  5. Install third gear band servo cover (59) into the third gear band servo bore in the transmission case.
    6. Fig 3: Locating 3rd Gear Servo Cover Retaining Ring
    GM749475Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If the third gear band servo cover retaining ring (60) is deformed, replace it.
  6. Using snap ring pliers, install the third gear band servo cover retaining ring (60) while pressing the third gear band servo cover into the third gear band servo bore to properly seat the retaining ring.
scientia non olet · About LEMON Manuals