Tools Required

J 28585  Snap Ring Remover. See Special Tools .

Fig 1: View Of Second Clutch Backing Plate Retaining Ring
Courtesy of GENERAL MOTORS CORP.
1. Using J 28585  remove the second clutch backing plate retaining ring (220) from the fluid pump assembly. See Special Tools .
Fig 2: View Of Second Clutch Assembly
Courtesy of GENERAL MOTORS CORP.
2. Remove the second clutch backing plate (219).
3. Remove the 4 fiber plates (217).
4. Remove the 4 steel plates (218).
Fig 3: View Of Second Clutch Spring Assembly
Courtesy of GENERAL MOTORS CORP.
5. Remove the second clutch spring assembly (215).
Fig 4: View Of Second Clutch Spring Assembly Retaining Ring
Courtesy of GENERAL MOTORS CORP.
6. Remove the second clutch spring assembly retaining ring (214).
Fig 5: View Of Second Clutch Piston
Courtesy of GENERAL MOTORS CORP.
CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.
7. While pulling on the piston by hand, apply compressed air into the fluid passage and remove the second clutch piston (210) and the second clutch piston sleeve (212).
8. Remove the second clutch piston outer seal (209) from the second clutch piston (210).
9. Remove the second clutch piston sleeve seals (211, 213) from the second clutch piston sleeve (212).