LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Hood Hinge Cable
    GM930888Courtesy of GENERAL MOTORS CORP.
  1. Install the hood primary latch release cable and grommet through the front of the dash.
  2. Slide the hood release handle into the hinge pillar and secure into place.
    3. Fig 2: View Of Center Pillar Lower Garnish Molding
    GM965599Courtesy of GENERAL MOTORS CORP.
  3. Reposition the carpet and install the front carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement .
    4. Fig 3: View Of Latch Release Cable
    GM930872Courtesy of GENERAL MOTORS CORP.
  4. Route the hood cable through the body structure.
  5. Install the hood latch. Refer to Hood Primary and Secondary Latch Replacement (Equinox)  or Hood Primary and Secondary Latch Replacement (Torrent) .
  6. Inspect the hood primary latch release cable for proper operation.
  7. Close the hood.
scientia non olet · About LEMON Manuals