Removal Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Brake Fluid Irritant Warning .

CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

Fig 1: Disconnecting/Connecting Brake Fluid Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Remove the underhood electrical center bracket. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
Disconnect the electrical connector from the brake fluid level indicator switch.

Fig 2: Disconnecting/Connecting Brake Pipes From Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Disconnect the brake pipes from the master cylinder.

NOTE: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.

Plug the open brake pipe ends.

Fig 3: Removing/Installing Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Remove master cylinder mounting nuts.
Remove the master cylinder from the vehicle.
Drain the master cylinder reservoir of all brake fluid.