LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Clutch Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Clutch Field Coil
    GM1654124Courtesy of GENERAL MOTORS CORP.
  1. Clean the clutch field coil and the pulley mounting surfaces.
  2. Install the clutch field coil to the compressor.
    3. Fig 2: View Of Clutch Field Coil Screws
    GM1654121Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the clutch field coil screws to the compressor and tighten the screws to 4.9 N.m (43 lb in).
    4. Fig 3: View Of Clutch Field Coil Connector Bracket Screw
    GM1654117Courtesy of GENERAL MOTORS CORP.
  4. Install the clutch field coil connector bracket screw to the compressor and tighten the screw to 4.3 N.m (38 lb in).
    5. Fig 4: View Of GE-47851 Installing The Compressor Pulley
    GM1654128Courtesy of GENERAL MOTORS CORP.
  5. Using GE-47851  , install the compressor pulley to the compressor. See Special Tools .
    6. Fig 5: View Of Compressor Pulley Snap Ring
    GM1654113Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure that the compressor pulley snap ring is installed with the rounded edge face up.
  6. Install the snap ring to the compressor pulley.
  7. Install the compressor clutch shims to the compressor shaft.
  8. Align the compressor clutch with the compressor shaft and install to the compressor.
    9. Fig 6: View Of GE-47851 Installing The Compressor Clutch
    GM1654132Courtesy of GENERAL MOTORS CORP.
  9. Using GE-47851  , install the compressor clutch to the compressor. See Special Tools .
    10. Fig 7: Checking Compressor Clutch To Compressor Pulley Clearance
    GM1654136Courtesy of GENERAL MOTORS CORP.
  10. Using a feeler gage, check the clearance between the compressor clutch and the compressor pulley. Ensure the clearance is 0.3 mm to 0.6 mm (0.012 in to 0.024 in).
  11. Once the correct air gap is obtained, install the new clutch bolt.
  12. Using J 37872  to hold the compressor clutch, tighten the clutch bolt to 21 N. See Special Tools .m (16 lb ft).
  13. After the clutch bolt is installed, verify that the compressor pulley spins freely.
  14. Install the compressor to the vehicle. Refer to Air Conditioning Compressor Replacement (LNJ)  or Air Conditioning Compressor Replacement (LY7) .
scientia non olet · About LEMON Manuals