LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Engine Mechanical - 3.4L) >> Repair Instructions - On Vehicle >> Cylinder Head Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine coolant from the cooling system. Refer to Cooling System Draining and Filling (LNJ GE 47716 Fill) or Cooling System Draining and Filling (LNJ Static Fill) .
  2. Remove the engine left side spark plug wires from the spark plugs. Refer to Spark Plug Wire Replacement .
    3. Fig 1: View Of Spark Plug Wire Support & Bolt
    GM1087864Courtesy of GENERAL MOTORS CORP.
  3. Remove the spark plug wire retainer support bolt (2) and support (1).
  4. Remove the engine left side spark plugs. Refer to Spark Plug Replacement .
  5. Remove the left valve rocker arm cover. Refer to Valve Rocker Arm Cover Removal - Left Side .
  6. Remove the lower intake manifold. Refer to Lower Intake Manifold Replacement .
  7. Remove the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement .
  8. Remove the exhaust crossover pipe. Refer to Exhaust Crossover Pipe Replacement (LNJ) .
  9. Remove the engine left side exhaust manifold. Refer to Exhaust Manifold Replacement - Left Side (LNJ) .
    10. Fig 2: View Of Cylinder Head
    GM52299Courtesy of GENERAL MOTORS CORP.
  10. Remove the cylinder head bolts and discard.
  11. Remove the cylinder head.
    12. Fig 3: View Of Cylinder Head Gasket And Alignment Pins
    GM54362Courtesy of GENERAL MOTORS CORP.
  12. Remove the cylinder head gasket.
    13. NOTE: All gasket mating surfaces must remain free of oil and foreign material. Refer to Adhesives, Fluids, Lubricants, and Sealers  for the correct part number to use to clean surfaces.
  13. Clean the following areas:
    • The gasket sealing surfaces on the cylinder head, cylinder block, intake manifold, and exhaust manifold
    • The cylinder block bolt threads
scientia non olet · About LEMON Manuals