Installation Procedure
WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Align the recirculation actuator with the door shaft and rotate into position.
- Install the recirculation actuator screws to the HVAC module.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Connect the electrical connector to the recirculation actuator.
- Calibrate the actuators. Refer to Actuator Recalibration .
- Cycle the ignition and verify proper operation.
- Install the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement .
CAUTION:
Refer to Fastener Caution
.