LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Engine Mechanical - 3.6L (2 Of 5)) >> Repair Instructions - On Vehicle (1 Of 2) >> Cylinder Head Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. If necessary, perform the following steps:
    1. Assemble the cylinder head. Refer to Cylinder Head Assemble .
    2. Install the camshaft. Refer to Camshaft Installation - Right Side .
    3. Install the exhaust manifold to the cylinder head. Refer to Exhaust Manifold Installation - Right Side .
    2. Fig 1: View Of Right Cylinder Head Gasket
    GM902817Courtesy of GENERAL MOTORS CORP.
  2. Install a NEW cylinder head gasket.
    3. Fig 2: View Of Right Cylinder Head
    GM902818Courtesy of GENERAL MOTORS CORP.
  3. Using the aid of an assistant, carefully install the cylinder head with the exhaust manifold to the engine. Refer to Cylinder Head Installation - Right Side .
  4. Install the power steering hose retainer.
  5. Connect and clip the HO2S wiring harness.
  6. Install the ground wires to the cylinder head.
  7. Install the right side catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LY7) .
  8. Install the right bank secondary timing chain. Refer to Secondary Camshaft Drive Chain Replacement - Right Side .
scientia non olet · About LEMON Manuals