Inflatable Restraint Passenger Presence System Replacement - Front

Fig 1: View Of Inflatable Restraint Front Passenger Presence System

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. CAUTION: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup . Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .
1	Inflatable Restraint Front Passenger Presence System Assembly Tip: The passenger presence system is an integral part of the pad on the passenger seat cushion. The sensor, module and seat cushion pad must be replaced as a unit. Note the routing of the wiring harness and connector location for installation.

Callout

Component Name

CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

CAUTION: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Remove the front seat. Refer to Front Seat Replacement - Bucket .
Remove the seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .

Inflatable Restraint Front Passenger Presence System Assembly
Tip:

The passenger presence system is an integral part of the pad on the passenger seat cushion.
The sensor, module and seat cushion pad must be replaced as a unit.
Note the routing of the wiring harness and connector location for installation.