LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G5 Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Primary Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

  1. Tape the feeder wire onto the end of the new cable.
    2. Fig 1: View Of Hood Cable Routing
    GM863925Courtesy of GENERAL MOTORS CORP.
  2. Use the feeder wire to pull the cable through the cowl grommet into the engine compartment.
  3. Install the hood primary latch release cable through the hole in the instrument panel.
  4. Remove the feeder wire from the hood release cable.
  5. Install the hood release cable handle assembly onto the bracket.
    6. Fig 2: View Of Left Front Carpet Retainer
    GM863873Courtesy of GENERAL MOTORS CORP.
  6. Install the front carpet retainer. Refer to Front Carpet Retainer Replacement (Coupe) or Front Carpet Retainer Replacement (Sedan) .
    7. Fig 3: View Of Hood Release Cable
    GM863872Courtesy of GENERAL MOTORS CORP.
  7. Connect the hood release cable to the latch.
  8. Inspect the hood latch cable for proper operation.
  9. Close the hood.
scientia non olet · About LEMON Manuals