Rear Side Door Window Replacement

Preliminary Procedure

1. Remove rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
2. Remove rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
3. Remove inner belt seal. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
4. Remove rear door frame appliques. Refer to Rear Door Frame Applique Replacement .
5. Remove rear window run channel. Refer to Rear Side Door Window Channel Replacement .
6. Lower window to access release tab.

1. Pull window out of the regulator guide plate.
2. Slide window down and out of primary run channels.
3. Remove window by tilting outboard and pulling window out of door.
4. When re-installing, slide window into door through outside.
5. Install window into primary run channels and position into regulator guide plate.
6. Operate window to inspect operation.