Conditions for Clearing the MIL/DTC

WARNING: This page is about a different variant/trim than selected.

The ECM turns OFF the MIL after the sixth consecutive drive trip in which the TCM does not send a MIL illumination request.
A scan tool can clear the MIL/DTC.
The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without an emission related diagnostic fault occurring.
The TCM cancels the default actions when the ignition is OFF long enough in order to power down the TCM.

DTC P1833

Step	Action	Value(s)	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Turn ON the ignition with the engine OFF. IMPORTANT: Before clearing the DTC, use the scan tool in order to record the ECM Freeze Frame and the TCM Failure Records. Using the Clear Info function erases the Freeze Frame and Failure Records from the ECM and the TCM. Using the Clear Info function erases stored DTCs in both the ECM and TCM. Record the DTC Freeze Frame and Failure Records. Clear the DTC. Turn OFF the ignition for at least 30 seconds. Start the engine. Did DTC P1833 reset?	-	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections
3	Turn OFF the ignition. Disconnect the AT inline 20-way connector. Turn ON the ignition with the engine OFF. Clear the DTC. Turn OFF the ignition for at least 30 seconds. Start the engine. Additional DTCs may set. Did DTC P1833 reset?	-	Go to Step 4	Go to Step 5
4	Disconnect the TCM. Test the solenoid supply voltage circuit between the AT inline 20-way connector and the TCM for a short to ground. Refer to Testing for Short to Ground and Wiring Repairs . Did you find and correct the condition?	-	Go to Step 9	Go to Step 7
5	Test the solenoid supply voltage circuit between the AT inline 20-way connector and each individual solenoid for a short to ground. Refer to Testing for Short to Ground . Did you find a condition?	-	Go to Step 8	Go to Step 6
6	Replace the shorted solenoid. Refer to 1-2 Shift Solenoid Valve Replacement , 2-3 Shift Solenoid Valve Replacement , 4-5 Shift Solenoid Replacement or Torque Converter Clutch Solenoid Replacement , as applicable. Is the action complete?	-	Go to Step 9	-
7	Replace the TCM. Refer to Control Module References for replacement, setup and programming. Is the action complete?	-	Go to Step 9	-
8	Replace the internal transmission electrical harness. Refer to Transmission Internal Electrical Harness Replacement . Is the action complete?	-	Go to Step 9	-
9	Perform the following procedure in order to verify the repair: Select DTC. Select Clear Info. Start the engine. Select Specific DTC. Enter DTC P1833. Has the test run and passed?	-	Go to Step 10	Go to Step 2
10	With the scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed?	-	Go to Diagnostic Trouble Code (DTC) List - Vehicle	System OK