Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the flywheel, if equipped with a manual transmission.
- Install the flywheel bolts.
Tighten: Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059 .
- Install the flywheel if equipped with an automatic transmission.
- Install the flywheel bolts.
Tighten: Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059 .
- Remove the J 38122-A . See Special Tools .
- Install the clutch, if equipped. Refer to Clutch Drive Plate and Clutch Driven Plate .
- Install the automatic transmission, if equipped. Refer to Transmission Replacement .
NOTE:
Refer to Fastener Notice
.