LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls & Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.
    Fig 1: Fuel Sending Unit Access Cover
    GM1594369Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
  2. Remove the fuel pump module access cover bolts.
  3. Remove the fuel pump module access cover.
    4. Fig 2: Fill Pipe Housing
    GM1594362Courtesy of GENERAL MOTORS CORP.
  4. Remove the fuel fill pipe housing bolts.
  5. Remove the fuel fill pipe housing.
  6. Remove the rear wheelhouse liner. Refer to Rear Wheelhouse Liner Panel Replacement .
    7. Fig 3: Fill Pipe Ground Strap Bolt
    GM1594365Courtesy of GENERAL MOTORS CORP.
  7. Remove the fill pipe ground strap bolt (2).
  8. Disconnect the fuel tank fill evaporative emission (EVAP) line quick connect fitting (3). Refer to Plastic Collar Quick Connect Fitting Service .
  9. Loosen the fuel fill pipe hose clamp (1) at the fuel tank.
  10. Separate and remove the fuel fill pipe hose assembly.
  11. Cover or plug the fuel tank opening and the EVAP line in order to prevent fuel loss and/or system contamination.
scientia non olet · About LEMON Manuals