LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 5L40-E/5L50-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Torque Converter Fluid Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Torque Converter Seal
    GM812733Courtesy of GENERAL MOTORS CORP.
  1. Assemble J 8092  onto J 44766  . See Special Tools .
  2. Install the torque converter seal onto the tool before installing into the case to prevent damage to the seal.
    3. IMPORTANT: Align the torque converter seal with the bolt holes.
  3. Install the torque converter seal into the torque converter housing.
    4. NOTE: Refer to Fastener Notice .
  4. Install the torque converter seal bolts.

    Tighten:  Tighten the NEW torque converter seal bolts to 3.6 N.m (32 lb in).

  5. Install the transmission torque converter. Refer to Torque Converter Replacement .
scientia non olet · About LEMON Manuals