LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 5L40-E/5L50-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pressure Test Hole Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pressure Test Plug
    GM792887Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install a NEW oil pressure test plug.

    Tighten:  Tighten the oil pressure test plug to 11 N.m (97 lb in).

  2. Check the transmission fluid level (fill if necessary). Refer to Transmission Fluid Checking .
  3. Install the front closeout panel. Refer to Floor Panel Tunnel Panel Front Closeout Panel Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals