Wiring Harness Installation
WARNING: This page is about a different variant/trim than selected.
- Install the wiring harness connector (55) thru the case (24). Hold the connector and install the wiring harness connector retainer (54).
- Route the harness to the valve body and connect the following components:
- Pressure Control Solenoid (357)
- TCC PWM Solenoid (352)
- 1-2 Shift Solenoid (368)
- 2-3 Shift Solenoid (369)
- 4-5 Shift Solenoid (376)
- Internal Mode Switch - IMS (602)
- Input Speed Sensor (44)
- Output Speed Sensor (42)