Torque Converter Housing Installation

Tools Required 

J 36850  Transjel Lubricant

Fig 1: Measuring Dimension X
Courtesy of GENERAL MOTORS CORP.
1. Measure the distance from the bottom of the gage bar to the top of the direct and reverse clutch assembly (6). Record this as dimension X. Refer to the Reverse Clutch Housing Selective Thrust Washer Specifications  to determine the correct size to use.
Fig 2: Locating Torque Converter Fluid Seal
Courtesy of GENERAL MOTORS CORP.
2. Use J 36850  to install the NEW torque converter fluid seal (4) onto the torque converter housing.
3. Use J 36850  to install the reverse clutch housing thrust washer (5).
Fig 3: Installing Fluid Pump Cover Gasket
Courtesy of GENERAL MOTORS CORP.
4. Install the NEW fluid pump cover gasket (46).
5. Install the torque converter housing (3) onto the case (24).
6. Install the torque converter housing bolts (2) and hand tighten.
Fig 4: Identifying Torque Converter Housing Bolts Tightening Sequence
Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to Fastener Notice .
7. Tighten the torque converter housing bolts in sequence.

   Tighten:  Tighten the housing bolts to 22 N.m (16 lb ft).