LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 5L40-E/5L50-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Prop Flange Assemble

Prop Flange Assemble

WARNING: This page is about a different variant/trim than selected.

Tools Required

    Fig 1: Prop Shaft Flange
    GM1700073Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW output shaft assembly retainer (30).
  2. Install the NEW prop shaft flange o-ring seal (32) into the prop shaft flange (31) - model dependent.
  3. Install the prop shaft flange (31).
  4. Put the transmission in Park.
    5. NOTE: Refer to Fastener Notice .
  5. Install the NEW prop shaft flange thrust washer (33) and NEW prop shaft flange nut (34) using GM P/N 89021297.

    Tighten:  Tighten the prop shaft flange nut (34) to 57 N.m (42 lb ft).

  6. Using either the J 45012  - CTS or J 8614-01  - solstice to tighten the prop flange nut.
scientia non olet · About LEMON Manuals