LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 5L40-E/5L50-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Output Shaft and Rear Internal Ring Gear Assemble

Output Shaft and Rear Internal Ring Gear Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Output Shaft and Rear Internal Ring Gear Inspection Areas
    GM952025Courtesy of GENERAL MOTORS CORP.
  1. Inspect the output shaft (562) and the rear internal gear (560) for the following:
    • Damaged or worn bushings
    • Damaged splines
    • Damaged or worn snap ring (563)
    • Damaged or worn gear teeth
    • Damaged or worn snap ring groove
    • Damaged or cross-threaded threads
    • Damaged or worn bearings
    2. Fig 2: Locating Output Shaft
    GM952018Courtesy of GENERAL MOTORS CORP.
  2. Install the output shaft (562) onto the rear internal gear (560).
  3. Install the snap ring (563) onto the rear internal ring gear (560). Be sure it is seated in the groove.
    4. Fig 3: View Of Output Shaft Assembly
    GM952029Courtesy of GENERAL MOTORS CORP.
  4. Rotate the transmission 90 degrees.
  5. Install the ouput shaft assembly (21) into the case (24).
scientia non olet · About LEMON Manuals