Trunk Ajar Indicator Inoperative
Trunk Ajar Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics or Release Systems Schematics Connector End View Reference: Displays and Gages Connector End Views |
|||
| 1 | Did you review the Luggage Compartment Description and Operation, and perform the necessary inspections? | Go to Step 2 | Go to Luggage Compartment Description and Operation |
| 2 | Open the rear compartment. Does the trunk ajar indicator illuminate? |
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Connect a fused jumper between the rear compartment lid ajar switch signal circuit and the rear compartment lid ajar switch ground circuit. Does the trunk ajar indicator illuminate? |
Go to Step 7 | Go to Step 6 |
| 5 | Test for an open or high resistance in the signal circuit of the rear compartment lid latch. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 6 | Test for an open or high resistance in the ground circuit of the rear compartment lid latch. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | - |
| 7 | Inspect for poor connections at the harness connector of the rear compartment lid latch. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 8 |
| 8 | Replace the rear compartment lid latch. Refer to Rear Compartment Lid Latch Replacement
. Did you find and correct the condition? |
Go to Step 10 | - |
| 9 | Replace the driver information center (DIC). Refer to Control Module References
for replacement, setup, and programming. Did you find and correct the condition? |
Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |