LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> Engine Support Fixture >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
  2. Raise the hood.
  3. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
    4. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  4. Disconnect the negative battery cable.
  5. Install the J 28467-VIBE  onto the strut attaching studs. See Special Tools .
  6. Install the J 28467-5A Strut Tower Support Assemblies over the J 28467-33A Thread Support Nuts.
  7. Install the J 28467-53 T-bolts with 5/16 inch washers through the J 28467-5A into the J 28467-33A and hand tighten.
  8. Install the two J 28467-1A Cross Bracket Assemblies over the J 28467-3 Strut Tower Tube.
  9. Install the J 28467-3 into the J 28467-5A.
  10. Install the J 28467-10 1/2 inch x 2.5 inch quick release pin through the J 28467-5A and the J 28467-3 on one side only.
  11. Hand tighten the passenger side J 28467-1A wing nuts.
  12. Hand tighten the lift hook wing nut securely to remove all slack from the engine support fixture assembly.
scientia non olet · About LEMON Manuals