LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 1.8L (LNK)) >> Repair Instructions >> Crankshaft Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the front seal and the sealing surface of the crankshaft pulley with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
  2. Install the crankshaft pulley onto the crankshaft indexing keyway.
    3. Fig 1: Pinion Flange Holder
    GM234382Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the crankshaft pulley retaining bolt using J 8614-01  to prevent crankshaft rotation when tightening the bolt. See Special Tools .

    Tighten:  Tighten the bolt to 118 N.m (87 lb ft).

  4. Install the right splash shield.
  5. Lower the vehicle.
  6. Install the accessory drive belt. Refer to Drive Belt Replacement .
  7. Connect the negative battery cable.

    Tighten:  Tighten the battery cable bolt to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals