Hazard Lamps Always On

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics
1	Did you review the Lighting System Description and Operation and perform the necessary inspections?	Go to Step 2	Go to Symptoms - Lighting Systems
2	Verify that the hazard lamps are always on. Does the system operate normally?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Remove the hazard switch Did the hazard lamps turn off?	Go to Step 4	Go to Step 5
4	Replace the hazard switch. Refer to Hazard Warning Switch Replacement . Is the replacement complete?	Go to Step 8	-
5	With the hazard switch and flasher relay removed. Check for continuity to ground between cavity 4 of the hazard switch and cavity 8 of the flasher relay. Refer to Circuit Testing in Wiring Systems. Is a ground present?	Go to Step 6	Go to Step 7
6	Repair short to ground between cavity 4 of the hazard switch and cavity 8 of the flasher relay. Refer to Wiring Repairs in Wiring Did you complete the repair?	Go to Step 8	-
7	Replace the flasher relay. Refer to Hazard and Turn Signal Flasher Replacement Did you complete the replacement?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3